Adding and removing drives
101
Adding and removing hardware
.
To install a drive in the lower drive bay:
1
Disconnect the cables from the existing drive.
2
Remove the 3.5-inch drive bay from the housing by
pressing the tab on top and pivoting the drive bay
outward.
Note
When installing drives in
the lower drive bay, the
hard disk drive is always
below the 3.5-inch diskette
drive.
66xarg.book : 66xach6.fm Page 101 Tuesday, June 30, 1998 10:18 AM
To Next Page
Loading...
Need help?
General