II
Communications adapter position
1 Single line card (type 2612)
2 Double line card (type 2609)
Note:
If
necessary, attach the appropriate adapter to the cable for installation.
6 Connect the ac power cord
to
the back of the
9401
System Unit (see Figure
2-1
on
page 2-3).
Note:
Do
not plug the power cord into the electrical outlet. You will be instructed when to provide
ac power.
7 Control panel locations:
Cover Closed
Cover Open
®
=
= =
~
,r
~
RV3D265-1
Figure 2-2. Control Panel Locations
l1
Power
On
Light: Lights when there
is
power to the 9401.
Note: The Power
On
light blinks while the system
is
powering
on
and while the system
is
powering off from Manual mode.
El
Processor Active Light: Blinks when programs are running.
II
System Attention Light: Lights when the system requires attention from the operator or
service representative.
2-4 AS/400
9401
Installation - Models P03 and
108
V3R1
To Next Page
Loading...
