4
In
the blank area of the cable labels (at both ends), write
B.
This is the location of the adapter
card.
RSLU013-1
5
Do
you have card type 2612 installed in positi
on
B of the
9401
System Unit?
Yes
No
~
Go to step 7 of this procedure.
6 Connect the communications cable to the adapter card (see Figure
4-1
).
Be sure to tighten the
thumbscrews.
Warning: Carefully
al
ign the cable connector with the card connector to ensure that you do not
bend the pins.
Go to step 9 of this procedure.
RV30 27
3-1
Figure 4-1. Card
Type
2612 in Position B for Twinaxial
or
ASCII as the System Console.
7 Connect the cable attachment cable to the adapter card in position B (see Figure 4-2). Be sure to
tighten the thumbscrews.
Warning: Care-fully align the cable connector with the card connector to ensure that you do not
bend the pins.
4-2 AS/400 94
01
In
sta
ll
ation - Models
P0
3 and 105 V3R1
To Next Page
Loading...
