RV30280-0
Figure 4-2. Card Type 2609 in Position B for Twinaxial, ASCII,
or
Client Access/400 Console as the System
Console.
8 Connect the system-unit end of the modem cable to connector
P1
of the cable attachment cable
(which
is
connected to the adapter card
in
position
B)_
See Figure 4-2
on
page 4-3. Be sure to
tighten the thumbscrews.
9
Is
the modem that you are using for ECS
an
IBM product?
Yes
No
Go to step 12 of
th
is procedure.
10
Is
the modem that you are using for ECS an IBM 5853?
No
Yes
Go to step 17 of this procedure.
11
Is
the modem that you are using for ECS
an
IBM 7855?
No
Yes
Go to step 18 of this procedure.
12 Use the modem information for instructions
on
how to set up the modem.
13 Ensure the following settings are correct:
• Answer tone
• Carrier disconnect wait time
• Injected tone
• Receiver sensitivity
• Delay time between the ring and the modem response
Not
e:
You
may need to contact your telephone compa
ny
or the Post Telephone a
nd
Telegra
ph
Administration to determine the correct settings.
Cha
pt
er 4. Connect the Cable a
nd
Modem for El
ec
t
ro
nic Cust
om
er
Su
pport 4-3
To Next Page
Loading...
