IBM Aspera HST User Manual

| Configure the Server from the Command Line | 43
see User, Group and Default Configurations on page 315 and run the following command to retrieve a complete
default aspera.conf that includes the asconfigurator syntax for each setting:
# /opt/aspera/bin/asuserdata -+
1.
Open aspera.conf from the following location:
/opt/aspera/etc/aspera.conf
2.
Add or locate the <transfer/> section, as in the following example:
<transfer>
<in>
<bandwidth>
<aggregate>
<trunk_id>Disabled</trunk_id> <!-- Incoming VLink ID -->
</aggregate>
<flow>
<target_rate>
<cap></cap> <!-- Incoming Target Rate Cap -->
<default>10000</default> <!-- Incoming Target Rate Default -->
<lock>false</lock> <!-- Incoming Target Rate Lock -->
</target_rate>
<min_rate>
<cap></cap> <!-- Incoming Minimum Rate Cap -->
<default>0</default> <!-- Incoming Minimum Rate Default -->
<lock>false</lock> <!-- Incoming Minimum Rate Lock -->
</min_rate>
<policy>
<allowed>any</allowed <!-- Incoming Policy Allowed -->
<default>fair</default> <!-- Incoming Policy Default -->
<lock>false</lock> <!-- Incoming Policy Lock -->
</policy>
<priority>
<cap></cap> <!-- Incoming Priority Allowed -->
<default>normal</default> <!-- Incoming Priority Default -->
<lock>false</lock> <!-- Incoming Priority Lock -->
</priority>
<network_rc>
<module>delay</module> <!-- Incoming Rate Control Module -->
<tcp_friendly>false</tcp_friendly> <!-- Incoming TCP Friendly Mode -->
<predictor>unset</predictor> <!-- Incoming Traffic RTT Predictor -->
<target_queue>unset</target_queue> <!-- Incoming Rate Control Target Queue -->
</network_rc>
</flow>
</bandwidth>
</in>
<out>
<bandwidth>
<aggregate>
<trunk_id>Disabled</trunk_id> <!-- Outgoing VLink ID -->
</aggregate>
<flow>
<target_rate>
<cap>Unlimited</cap> <!-- Outgoing Target Rate Cap -->
<default>10000</default> <!-- Outgoing Target Rate Default -->
<lock>false</lock> <!-- Outgoing Target Rate Lock -->
</target_rate>
<min_rate>
<cap>Unlimited</cap> <!-- Outgoing Minimum Rate Cap -->
<default>0</default> <!-- Outgoing Minimum Rate Default -->
<lock>false</lock> <!-- Outgoing Minimum Rate Lock -->
</min_rate>
<policy>
<allowed>any</allowed> <!-- Outgoing Policy Allowed -->
<default>fair</default> <!-- Outgoing Policy Default -->
<lock>false</lock> <!-- Outgoing Policy Lock -->
</policy>
<priority>
<cap>high</cap> <!-- Outgoing Priority Allowed -->
<default>normal</default> <!-- Outgoing Priority Default -->
<lock>false</lock> <!-- Outgoing Priority Lock -->
</priority>
<network_rc>
<module>delay</module> <!-- Outgoing Rate Control Module -->
<tcp_friendly>false</tcp_friendly> <!-- Outgoing TCP Friendly Mode -->
<predictor>unset</predictor> <!-- Outgoing Traffic RTT Predictor -->

IBM Aspera HST Specifications

General

Brand	IBM
Model	Aspera HST
Category	Server
Language	English