| Configure the Server from the Command Line | 51
Field Description Values Default
but less aggressive when sharing
bandwidth with other network traffic.
When congestion occurs, the transfer
rate is reduced to the minimum rate
until other traffic decreases.
• fixed - Attempt to transfer at the
specified target rate, regardless of
network or storage capacity. This can
decrease transfer performance and
cause problems on the target storage.
Aspera discourages using the fixed
policy except in specific contexts,
such as bandwidth testing. The fixed
policy requires a maximum (target)
rate.
Outgoing Bandwidth
Policy Lock
Lock the bandwidth policy of outgoing
transfer sessions to the default value (set
to true). Set to false to allow users to
adjust the bandwidth policy.
true or false false
Outgoing Priority
Allowed
The highest priority your client can
request. Use the value 0 to unset this
option; 1 to allow high priority, 2 to
enforce normal priority.
0, 1, or 2 1
Outgoing Priority Default The initial priority setting. Use the value
0 to unset this option, 1 to allow high
priority; 2 to enforce normal priority.
0, 1, or 2 2
Outgoing Priority Lock To prevent your clients from changing the
priority, set the value to true.
true or false false
Outgoing Rate Control
Module
Set how the transmission rate should
be managed relative to instantaneous
network bandwidth availability. Aspera
recommends that this option be changed
only by advanced users.
When the client does not specify a
configuration, the server configuration is
used. When the client specifies a value
other than delay and the client is the
receiver, then the client configuration
overrides the server configuration.
Values:
• delay: The baseline rate control
module used by Aspera transfers.
• delay-odp: A queue-scaling controller
for overdrive protection.
• delay-adv: An advanced rate
controller.
• delay-laq: A loss-adjusted queueing
(LAQ) rate controller.
delay, delay-
odp, delay-
adv, or delay-
laq
delay
To Next Page
Loading...
Need help?
General