Note: If this previously described sequence does not occur or you receive
an error message, see “Chapter 4. Problem solving” on page 39for
more information.
9. Turn on the devices connected to the host computer.
10. Verify that the library is installed correctly by looking for the library and drive
devices after turning on the host computer.
v If you are using Microsoft
®
Windows NT
®
, you can see if the library is
recognized by clicking Settings-->Control Panel-->SCSI Adapter and
expanding the device tree to view the library SCSI adapter.
v Or, during the boot sequence, you can press Cntrl a during the SCSI
adapter configuration. Select SCSI Select Utilities and then select SCSI
Disk Utilities to have the computer retrieve the SCSI bus and display all of
the attached SCSI devices.
11. If you do not already have backup/restore software installed, you can install
the complimentary trial software of your choice by inserting the CD into your
computer CD-ROM drive and following the onscreen instructions.
Installing the rack library
Follow these instructions to rack-mount the library.
v Statement 14
CAUTION:
The following label indicates moving parts nearby.
Mechanical Hazard Label
Part Number: C7200-84309-2
Rev A. Artwork Date: January 6, 1999
Color: Opaque PMS Process Black
Tools and parts
Before you begin, ensure that you have the following:
v Phillips #2 screwdriver
v Torx screwdriver with T20 bit
v 1/2-inch open-end wrench
8 LTO Library: User’s Guide
To Next Page
Loading...
Need help?
General