IBM LTO Library

Location of securing screws
Getting started with the library
After you install the library, perform the following to begin using the library.
v Enable the password.
v Configure the mailslot.
v Set the date and time.
v Configure library for web monitoring.
Enabling and changing the password
When the library is first installed, the password is inactive. Set a password to
protect the system from unauthorized access.
1. To enable and change the password, select Main Menu--> Administration-->
Change Configuration-->Password.
2. Enter the Password menu. A status screen will indicate if a password is
enabled.
v If the password is turned off, select Set New Password to enter the new
password.
v If the password is enabled, select Change Password to enter the new
password.
v If the password is enabled, select Turn Password Off to clear the password.
12 LTO Library: User’s Guide