Chapter 1. Installation
The IBM
®
®
LTO library is an automated storage and retrieval system that includes
one pre-installed LTO tape drive and 2 removable magazines that can each hold up
to 10 LTO data or cleaning cartridges. The LTO library comes in either a tower or
rack mount configuration. Both configurations can be expanded by adding a
second LTO tape drive upgrade (09N4048). The rack model can be further
expanded with second or third expander modules (3600LXU) for a total of up to 6
tape drives and 60 data cartridges.
Library features
In addition to this book, the library kit includes:
CD
9
7
8
«1¬SCSI external cable
«2¬SCSI terminator
«3¬SCSI jumper cable
«4¬AC power cord
«5¬Data cartridge
«6¬Cleaning cartridge
«7¬Quick install guide booklet
«8¬Barcode kit
«9¬Trial software CDs
Before you begin
Before you unpack and install the library, choose a location that meets the
following criteria.
Temperature 10-35║ C (50-95║ F)
Power source AC power voltage: 100-127 V or 200-240 V
Line frequency: 50-60 Hz
Air quality Minimal sources of particulate contamination. Avoid areas near frequently used doors and
walkways, stacks of supplies that collect dust, and smoke-filled rooms.
Attention: Excessive dust and debris can damage tapes and tape drives.
Humidity 20-80% RH
© Copyright IBM Corp. 2001 1
To Next Page
Loading...
Need help?
General