4. Plug the ribbon connector into the back of the drive module.
5. Gently fold the ribbon cable into the back of the drive module.
6. Holding the connector plate in place, tighten the thumbscrews on each side of
the connector.
Follow these directions to bring the new drive module online.
1. Use the + or - keys to select the drive module that has been replaced. Bring the
drive back online.
2. If you have increased the number of drives since the last power cycle, you
must turn the library on and then off, again, for the library to recognize the
additional drive.
The library will automatically run a self-test when the drive has been brought
online.
When the drive is successfully brought online, the new drive will adopt the SCSI
ID of the current drive position.
Note: You might need to use the host backup software to recognize the new drive
when you bring it online. If the software does not have the capability to
automatically detect the new drive, you might need to restart the host.
Adding expander module
Adding a second or third expander module (3600LXU) should be performed only
by a trained, service person. Please contact IBM to schedule this service.
Chapter 3. Maintenance 35
To Next Page
Need help?
General