a. To run the Recovery Guru, click Recovery Guru in the toolbar in the Subsystem Management
window.
b. Complete the recovery procedure.
If the Recovery Guru directs you to replace a failed component, locate and troubleshoot that
component. See “Checking the LEDs” on page 73.
c. When the procedure is completed, select Recheck in the Recovery Guru. This runs the Recovery
Guru again to make sure that the problem is corrected.
d. If the problem remains, contact your IBM technical-support representative.
11. Replace the bezel on the storage enclosure, if applicable.
88 IBM System Storage DCS3700: Installation, User, and Maintenance Guide
To Next Page
Loading...
