IBM System x3100 M4

Table 6. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v If an action step is preceded by “(Trained technician only),” that step must be performed only by a trained
technician.
806f0513-2582xxxx A PCI SERR has
occurred on system
%1.
(%1 =
CIM_ComputerSystem.
ElementName)
Error A PCI SERR has
occurred.
(Sensor = PCIs)
1. Check the PCI LED.
2. Reseat the affected adapters and
riser card.
3. Update the server firmware (UEFI
and IMM2) and adapter firmware.
Important: Some cluster solutions
require specific code levels or
coordinated code updates. If the
device is part of a cluster solution,
verify that the latest level of code
is supported for the cluster solution
before you update the code.
4. Make sure that the adapter is
supported. For a list of supported
optional devices, see
http://www.ibm.com/systems/info/
x86servers/serverproven/compat/
us/.
5. Replace the adapters.
6. Replace the riser cards.
806f0813-2582xxxx A Uncorrectable Bus
Error has occurred on
system.
(Sensor = PCIs)
Error A bus
uncorrectable error
has occurred.
(Sensor = Critical
Int PCI)
1. Check the system-event log.
2. Check the PCI LED.
3. Remove the adapter from the
indicated PCI slot.
4. Check for a server firmware
update.
Important: Some cluster solutions
require specific code levels or
coordinated code updates. If the
device is part of a cluster solution,
verify that the latest level of code
is supported for the cluster solution
before you update the code.
5. (Trained technician only) Replace
the system board (see “Removing
the system board” on page 258
and “Installing the system board”
on page 261).
Firmware and software messages
Chapter 3. Diagnostics 57