IBM System x3100 M4

Table 6. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v If an action step is preceded by “(Trained technician only),” that step must be performed only by a trained
technician.
4000000c-
00000000
OS Watchdog response
[arg1] by [arg2].
Info This message is
for the use case
where an OS
Watchdog has
been enabled or
disabled by a user.
No action; information only.
4000000d-
00000000
DHCP[%1] failure, no
IP address assigned.
(%1 = IP address,
xxx.xxx.xxx.xxx)
Info A DHCP server
has failed to
assign an IP
address to the
IMM.
Complete the following steps until the
problem is solved:
1. Make sure that the Chassis
Management Module network
cable is connected.
2. Make sure that there is a DHCP
server on the network that can
assign an IP address to the IMM.
4000000e-
00000000
Remote Login
Successful. Login ID:
[arg1] from [arg2] at IP
address [arg3].
Info The specified user
has logged in to
the Integrated
Management
Module.
No action; information only.
4000000f-00000000 Attempting to %1 server
%2 by user %3.
(%1 = Power Up,
Power Down, Power
Cycle, or Reset; %2 =
IBM_ComputerSystem.
ElementName; %3 =
user ID)
Info A user has used
the IMM to perform
a power function
on the server.
No action; information only.
40000010-
00000000
Security: Userid: '%1'
had %2 login failures
from WEB client at IP
address %3.
(%1 = user ID; %2 =
MaximumSuccessive
LoginFailures (currently
set to 5 in the
firmware); %3 = IP
address,
xxx.xxx.xxx.xxx)
Error A user has
exceeded the
maximum number
of unsuccessful
login attempts from
a web browser and
has been
prevented from
logging in for the
lockout period.
Complete the following steps until the
problem is solved:
1. Make sure that the correct login ID
and password are being used.
2. Have the system administrator
reset the login ID or password.
40000011-
00000000
Security: Login ID: '%1'
had %2 login failures
from CLI at %3.
(%1 = user ID; %2 =
MaximumSuccessive
LoginFailures (currently
set to 5 in the
firmware); %3 = IP
address,
xxx.xxx.xxx.xxx)
Error A user has
exceeded the
maximum number
of unsuccessful
login attempts from
the command-line
interface and has
been prevented
from logging in for
the lockout period.
Complete the following steps until the
problem is solved:
1. Make sure that the correct login ID
and password are being used.
2. Have the system administrator
reset the login ID or password.
64 IBM System x3100 M4 Type 2582: Problem Determination and Service Guide