IBM System x3100 M4

Table 6. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v If an action step is preceded by “(Trained technician only),” that step must be performed only by a trained
technician.
4000007d-
00000000
Power cap and external
throttling occurred.
Info Power cap and
external throttling
occurred.
No action; information only.
4000007e-
00000000
External throttling
occurred.
Info External throttling
occurred.
No action; information only.
4000007f-00000000 Power cap throttling
occurred.
Info Power cap
throttling occurred.
No action; information only.
40000080-
00000000
Remote Control session
started by user [arg1] in
[arg2] mode.
Info Remote Control
session started
No action; information only.
40000081-
00000000
PXE boot requested by
user [arg1].
Info PXE boot
requested.
No action; information only.
40000082-
00000000
The measured power
value has returned
below the power cap
value.
Info Power exceeded
cap recovered.
No action; information only.
40000083-
00000000
The new minimum
power cap value has
returned below the
power cap value.
Info Minimum Power
Cap exceeds
Power Cap
recovered
No action; information only.
40000084-
00000000
IMM firmware mismatch
between nodes [arg1]
and [arg2]. Please
attempt to flash the
IMM firmware to the
same level on all
nodes.
Info A mismatch of
IMM firmware has
been detected
between nodes.
No action; information only.
40000085-
00000000
FPGA firmware
mismatch between
nodes [arg1] and [arg2].
Please attempt to flash
the FPGA firmware to
the same level on all
nodes.
Error A mismatch of
FPGA firmware
has been detected
between nodes.
No action; information only.
40000086-
00000000
Test Call Home
Generated by user
[arg1].
Info Test Call Home
generated by user.
No action; information only.
40000087-
00000000
Manual Call Home by
user [arg1]: [arg2].
Info Manual Call Home
by user.
No action; information only.
40000088-
00000000
Management Controller
[arg1]: Configuration
restoration from a file
by user [arg2]
completed.
Info This message is
for the use case
where a user
restores a
Management
Controller
configuration from
a file and it
completes.
No action; information only.
78 IBM System x3100 M4 Type 2582: Problem Determination and Service Guide