Icom IC-440 - Receiving and Transmitting

15
3
BASIC OPERATION
3
D Zone type selection
(Available only when more than two zones are set.)
q
Push
F
SET
(Function) to enter the function mode, and push
and hold
LOW
(Zone) for 2 sec. to enter the zone select
mode.
w Push or to select the desired zone, then push
LOW
(Zone) again to set.
NOTE:
‘CB-05,’ ‘CB-R5’ and ‘CB-35’ channels are used for the
emergency. And ‘CB-22’ and ‘CB-23’ channels are used for
telemetry and telecommand applications, so voice communi-
cations are not available on these channels.
■ Receiving and transmitting
Receiving:
q Push and hold
for 2 sec. to turn the power ON.
• If “T SQL” appears on the display, push and hold
MONI
TSQL
for 2 sec.
once or twice to cancel the tone squelch or pocket beep. (pgs.
27, 28)
w Select the desired operating channel (p. 14).
• When receiving a signal, “ ” appears and audio is emitted from
the speaker.
• Further adjustment of volume level may be necessary at this
point. (p. 7)
• Push
MONI
TSQL
to toggle the monitor function ON and OFF.
MONI
F
SET
TSQL
PRIO
LOW
SCAN
O࡮G࡮P
CH
SET࡮P
RS
TAG
SQL
[PWR]
LOW
MONI
TSQL
IC-440-1.indd15IC-440-1.indd15 2008/06/2515:59:342008/06/2515:59:34