Icom IC-440 - TONE SQUELCH OPERATION; Tone Squelch and CTCSS;DTCS Setup

22
5
SCAN OPERATION
■ Scanning preparation
IC-440 scans all tagged channels, when a scan is initiated.
When the IC-440 fi nds a busy channel it can be set to pause
or resume after a pause (Scan Stop Timer). (Excluding re-
peater search scan).
(See Scan Stop Timer in Set mode. The default setting is
P5).
D Scan type selection
➥ Push
O࡮G࡮P
RS
(Scan Mode) several times to select the desired
scan type.
• Open, group and priority scans are available.
• “ ”, “ ” or “ ” is displayed for 0.5 sec. when each scan type
is selected.
D Tag channel setting
q Select the desired scan type. (See at left.)
w Select the desired channel. (p. 14)
e Push and hold
SCAN
TAG
(Scan Tag) for 2 sec. to toggle the tag
channel setting ON and OFF.
• “ ” appears when the tag setting is ON (The channel is set as
a scan channel).
To speed up scanning:
For open scan, cancel the tag channel setting to skip un-
desired channels such as usually busy channels.
For group scan, set only often-used channels as tag
channels.
All memory channels may be set as tag channels by de-
fault.
Open scan is selected.
Group scan is selected.
Priority scan is selected.
Push
Push
Push
Appears
Appears
Appears
O࡮G࡮P
RS
O࡮G࡮P
RS
O࡮G࡮P
RS
Appears
IC-440-1.indd22IC-440-1.indd22 2008/06/2515:59:362008/06/2515:59:36