Icom IC-440 - OTHER FUNCTIONS; Smart-Ring, ATS, RX Frequency, and Bandwidth

30
7
SELCALL OPERATION
e Push or to select the desired TX code channel.
r Push [PTT] to transmit to the selected TX code channel,
or push
SCAN
TAG
(TX Code CH) to set the selected TX code
channel and repeat q–e, then push [PTT] to transmit.
✓ CONVENIENT!
The TX code channel name can be assigned to the all 32 TX
code channel via the optional CS-440
CLONING SOFTWARE.
The TX code channel name allows you to easy to select the
channel, fi nd the channel user, and so on.
D TX code number edit
SCAN
TAG
(TX Code CH) enables you to change the TX code con-
tents within the allowable digits.
The group call function works by allowing you to edit a spe-
cial ‘group code’ of the SelCall ID code.
q Select the desired CB channel (‘CB-XX’) except for chan-
nels 5 and 35. (p. 14)
w Push
F
SET
(Function) to enter the function mode, then push
SCAN
TAG
(TX Code CH) to enter the TX code channel selection
mode.
• Push or to select the desired TX code channel, if de-
sired.
e Push and hold
SCAN
TAG
(TX Code CH) for 2 sec. again to enter
the TX code edit mode.
r Push
SCAN
TAG
(TX Code CH) to select the desired digit to be
edited.
Appears
Transmitting
The editable digit starts blinking
IC-440-1.indd30IC-440-1.indd30 2008/06/2515:59:392008/06/2515:59:39