Icom IC-440 - Open Scan; Setting Scan Resume Condition

23
5
SCAN OPERATION
5
D Setting scan resume condition
q Push and hold
F
SET
(Set Mode) for 2 sec. to enter set mode.
w Push
F
SET
* or
MONI
TSQL
* several times until “SCN-T” appears.
e Push
or to select the scan resume timer.
• 5 : Scan pauses for 5 sec. then resumes.
• 10 : Scan pauses for 10 sec. then resumes.
• 15 : Scan pauses for 15 sec. then resumes.
• P5 : Scan pauses until the signal disappears, then re-
sumes 5 sec. after the signal disappears.
( P5 is recommended for typical use and is the de-
fault setting).
r Push and hold
for 2 sec. to turn the power OFF, or
push and hold
F
SET
(Set Mode) for 2 sec. to exit set mode.
*Regardless of the assigned key function.
■ Open scan
Open scan searches for transmitted signals automatically
and makes it easier to locate new stations for contact or lis-
tening purposes.
IMPORTANT!:
Open scan can transmit on a start channel or busy channel.
q Push
O࡮G࡮P
RS
(Scan Mode) several times to select the open
scan. (p. 22)
• “ ” appears.
w Push
SCAN
TAG
(Scan) to start the open scan.
e
When receiving a signal, scan pauses and resumes accord-
ing to the selected scan resume condition. (see left column)
r Push
SCAN
TAG
(Scan) to cancel the scan.
[
Open scan is selected.
Appears
Blinks
Scan start channel
IC-440-1.indd23IC-440-1.indd23 2008/06/2515:59:372008/06/2515:59:37