44
9
SET MODE
D Scan resume timer
The scan resume condition can be set as a pause (P5) or
timer scan (15/10/5). When a signal disappears, scan re-
sumes after 5 sec. has passed regardless of the setting.
15/10/5 : Scan pauses for 15, 10 or 5 sec. when a signal is
detected, then resumes after that.
P5 : Scan pauses until the signal disappears and then
resumes after 5 sec. (Default and recommended
setting).
D Scan restart function
This function starts the scan after the transmission is per-
formed during scan and 10 sec. has passed.
D Roger Beep
This function emits a beep on the communication party to
inform the transmission is fi nished.
Scan resume timer
P5 (default)
10 sec. setting
Scan restart timer
OFF (default)
Scan restart timer ON
Roger beep OFF (default) Roger beep ON
IC-440-1.indd44IC-440-1.indd44 2008/06/2515:59:452008/06/2515:59:45
To Next Page
Loading...
