Icom IC-440 - Quiet Mode Operation; Selcall Operation; Stun Function

33
7
SELCALL OPERATION
7
■ Quiet mode operation
When the quiet mode operation is turned ON, the SelCall
mute is activated and allows the silent operation until receiv-
ing a SelCall.
➥ Push
F
SET
(Function) to enter the function mode, then push
O࡮G࡮P
RS
(Quiet) to toggle the quiet mode ON and OFF.
• “Q” appears when the quiet mode is in use.
To monitor the channel:
➥ Push
MONI
TSQL
(Monitor) to release the mute (audio is emitted.)
• “ ” blinks when the monitor function is in use.
To enable SelCall mute:
➥ When “ ” blinks, push
MONI
TSQL
(Monitor) to mute the channel.
• “
” disappears.
NOTE: The unmute condition may automatically return to
the mute condition after a specifi ed time period depending
on the pre-setting.
■ Stun function
When the transceiver is in the Stun condition, it will request
a password at power ON. This password is the same as the
Power ON password function. Once the password has been
input, the transceiver will not prompt for it to be input again.
Cloning and use of the transceiver is disabled when the kill
ID is received. By activating the clone write condition, the
transceiver can be returned to an usable condition.
(The internal data can not be accessed by the cloning read
condition.)
Appears
Blinks
IC-440-1.indd33IC-440-1.indd33 2008/06/2515:59:412008/06/2515:59:41