Icom IC-718

132
10
SET MODE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
Memopad Numbers 5
Sets the number of memo pad channels available.
5 or 10 memo pads can be selected. (default: 5)
MAIN DIAL Auto TS HIGH
Sets the auto tuning step function for the main dial.
When rotating the main dial rapidly, the tuning step
automatically changes several times as selected.
There are 2 type of auto tuning steps: HIGH
(Fastest) and LOW (Faster). (default: HIGH)
• HIGH : Auto tuning step is turned ON. Fastest tun-
ing step during rapid rotation. (default)
• LOW : Auto tuning step is turned ON. Faster tun-
ing step during rapid rotation.
• OFF : Auto tuning step is turned OFF.
MIC Up/Down Speed HIGH
Sets the rate at which frequencies are scanned
when the microphone [UP]/[DN] switches are
pushed and held. HIGH or LOW can be selected.
• HIGH : High speed (default; 50 tuning steps/sec.)
• LOW : Low speed (25 tuning steps/sec.)
Quick RIT/∂TX Clear OFF
Selects the RIT/∂TX frequency clearing instruction
with [CLEAR].
• ON : Clears the RIT/∂TX frequency when [CLEAR]
is pushed momentarily.
• OFF : Clears the RIT/∂TX frequency when [CLEAR]
is pushed and held for 1 sec. (default)
[NOTCH] Switch (SSB) Auto/Manual
Selects notch functions for SSB mode operation
from Auto, Manual and Auto/Manual.
• Auto : Only the auto notch can be used.
• Manual : Only the manual notch can be used.
• Auto/Manual : Both the auto and manual notch can
be used. (default)
[NOTCH] Switch (AM) Auto/Manual
Selects notch functions for AM mode operation from
Auto, Manual and Auto/Manual.
• Auto : Only the auto notch can be used.
• Manual : Only the manual notch can be used.
• Auto/Manual : Both the auto and manual notch can
be used. (default)
SSB/CW Synchronous Tuning OFF
Selects the displayed frequency shift function from
ON and OFF. (default: OFF)
When this function is activated, the audio pitch or
tones of the received signal will remain the same
even when the operating mode is changed between
SSB and CW.
The amount of frequency shift may differ accord-
ing to the CW pitch setting.
• ON : The displayed frequency shifts when the op
-
erating mode is changed between SSB and
CW.
• OFF : The displayed frequency does not shift.