Icom IC-7400 - Page 95

82
11
SET MODE
2001 NEW
11. Quick SPLIT
When this item is set to ON, pushing [SPLIT] for 1
sec. sets the transmit frequency using the displayed
frequency and the split offset, set in SPLIT Off-
set item below, and activates the split function au-
tomatically.
ON Quick split ON (default)
OFF Quick split OFF
11 ON
Quick SPLIT
12. SPLIT Offset
This item sets the offset (difference between transmit
and receive frequencies) for the quick split function.
The offset frequency can be set from –9.999 MHz to
+9.999 MHz in 1 kHz steps.
12 O.OOOMHz
SPLIT Offset
13. SPLIT LOCK
When this item is ON, the tuning dial can be used to
adjust the transmit frequency while pushing [XFC]
even while the dial lock function is activated.
ON Split lock function ON
OFF Split lock function OFF (default)
13 OFF
SPLIT LOCK
14. DUP Offset HF
This item sets the offset (difference between transmit
and receive frequencies) for duplex operation. How-
ever, this setting is used to input the repeater offset
for an HF band only.
The offset frequency can be set from 0.000 MHz to
9.999 MHz in 1 kHz steps.
14 O.1OOMHz
DUP Offset HF
15. DUP Offset 50M
This item sets the offset (difference between transmit
and receive frequencies) for duplex operation. How-
ever, this setting is used to input the repeater offset
for a 50 MHz band only.
The offset frequency can be set from 0.000 MHz to
9.999 MHz in 1 kHz steps.
15 O.5OOMHz
DUP Offset 5OM
■ General set mode (continued)
16. DUP Offset 144M
This item sets the offset (difference between transmit
and receive frequencies) for duplex operation. How-
ever, this setting is used to input the repeater offset
for a 144 MHz band only.
The offset frequency can be set from 0.000 MHz to
9.999 MHz in 1 kHz steps.
16 O.6OOMHz
DUP Offset 144M
IC-7400.qxd 02.4.2 11:35 Page 82