8
2
BASIC OPERATION
2
D Using the keypad
Enter the number of the desired channel number
using the keypad (0 to 9), then push [OK
≈≈
] on the
FRONT panel or microphone.
This way is convenient for remembering the usage
and stored channel number, or when changing large a
number of channels.
•Pushing [
ΩΩ
CLR] clears input digits and retrieves the chan-
nel.
Scan function repeatedly scans programmed chan-
nels. This function is convenient to wait for calls on
multiple channels.
q Push [MUTE] several times to select the voice
mute.
• The mute type indicator “V” appears.
w Push [SCAN] to start the scan.
• The “Scanning” indicator appears.
e When a signal is received, channel scan pauses
on that channel.
r Push any key to cancel the scan.
NOTE: The scan resume condition (the action after
signal receiving) can be selected as ‘SCAN RE-
SUME’ in the Initial set mode. (p. 45)
To Next Page
Loading...
Need help?
General
