33
5
CHANNEL/ID PROGRAMMING
■ Programming an ID
The IC-F7000 can be programmed three kind of IDs,
Selcall ID, TEL number, ALE ID.
DD
Editing an ID
q While pushing and holding [OK
≈≈
], turn power ON
to enter the Initial set mode.
2 kind of ID sizes, 4-digit or 6-digit, are available.
The ‘ID SIZE’ must be set first in the SELCALL
menu of the Initial set mode. (p.46)
w Push [
√√
] to select ‘ID LIST,’ then push [OK
≈≈
].
• Call selection menu appears.
e Push [
∫∫
]/[
√√
] to select the desired call type, then
push [OK
≈≈
].
• Push [
ΩΩ
CLR] to return the set mode menu
.
DD
Selcall
The IC-F7000 can be stored up to 10 your own IDs
and 90 calling (address) IDs (1–90). 10 your own ID
contains 5 selcall IDs (S1–S5) and 5 TEL call IDs
(T1–T5).
q Push [
∫∫
]/[
√√
] to select the desired ID channel, then
push [OK
≈≈
].
• Push [
ΩΩ
CLR] to return the call selection menu
.
• No displayed channel is a blank channel
.
• ID programming screen appears.
w After push [OK
≈≈
], edit the 4-digits of appropriate
ID (or 6-digits depending on ‘ID SIZE’ setting) by
using 10-keypad. Then push [OK
≈≈
].
e Push [
√√
] to enter the ID name programming, then
edit the name.
• ID name is available up to 15 characters
.
• Push [
ΩΩ
CLR] or [OK
≈≈
] to edit backspace or space,
respectively
r Push [
√√
] to select ‘CH’ for channel range setting,
then push [OK
≈≈
].
• Edit 4-digits channel number twice.
<Input example>
• Channel range from Ch 12 to Ch 320
Push /, /, z, x, then /, c, x, /
.
- Small number must be input first.
• Discontinuous channels Ch 12 and Ch 320
Push /, /, z, x and /, /, z, x, then push /, c,
x, / and /, c, x, /
.
- When input the discontinuous channel, enter the same
channel number twice.
• Deleting an ID number
q Select an ID number for deleting, push [OK
≈≈
].
w Push [
√√
] several times to select ‘DELETE NO,’
then push and hold [OK
≈≈
].
To Next Page
Loading...
Need help?
General
