Icom IC-F7000 Instruction Manual

53
6
SET MODE
Password (AUS version only)
This item confirms the individual password for ALE
operation. (see p.19)
é-PASSWORD----LOCKED
--PRE-AMP-----ON
--VOL-MIN-----0
--OFFSET-TIM--0:00
Preamplifier
This item sets the receiver preamplifier function ON
or OFF. (default: ON)
Turn this item ON when receiving weak signal.
é-PASSWORD----LOCKED
--PRE-AMP-----ç-ON-å
--VOL-MIN-----0
--OFFSET-TIM--0:00
Minimum audio level
This item sets the minimum audio level.
(default: 0)
Turn this item ON when receiving weak signal.
é-PASSWORD----LOCKED
--PRE-AMP-----ON
--VOL-MIN-----ç-0-å
--OFFSET-TIM--0:00
Offset time
Set the offset time between the UTC and local time
within –12:00 to +12:00 in 5 minutes steps.
(default: 0:00)
é-PASSWORD----LOCKED
--PRE-AMP-----ON
--VOL-MIN-----0
--OFFSET-TIM--ç-0:00-å
If you want to initialize the operating conditions (Quick
set mode setting, Initial set mode setting, VFO fre-
quency, selected channel) without channel contents
or ID contents.
q Turn the transceiver power OFF, if the transceiver
is powered ON.
w While pushing and holding both [
∫∫
] and [
√√
], push
[I/O] to reset the CPU.
[I/O]
[∫]/[√]
■ CPU reset

Icom IC-F7000 Specifications

General

Brand	Icom
Model	IC-F7000
Category	Transceiver
Language	English