24
4
SELCALL/ALE OPERATION
4
ï GPS Position call
The GPS Position call allows you to send your own
position/time information to the intended ID station.
• Preparation for GPS Position call
Sending a Selective Beacon call on several Selcall
channels, and check the propagation on each chan-
nel to select the channel of good signal quality. (p. 20)
• Sending GPS Position call
q Push [
∫∫
] or [
√√
] to select the desired channel for
Selcall.
w Push [CALL] momentarily to enter the Call menu.
e Push [
ΩΩ
CLR] or [OK
≈≈
] to select ‘GPS POSN.’
• ‘SELCALL,’ ‘GPS BCON,’ ‘GPS POSN,’ ‘EMER SEL-
CALL,’ ‘PAGECALL,’ ‘STATUS CALL,’ ‘SEL BCON’ are
selectable.
r Push [
√√
] to select ‘ID,’ then select an intended ID.
• Last selected ID is displayed.
• Enter the 4-digits (or 6-digits depending on Initial set
mode setting) number of the desired ID using 10-key-
pad directly. Or push [OK
≈≈
] to enter ID selection, push
[
∫∫
]/[
√√
] to select the pre-programmed ID, then push
[OK
≈≈
] to fix the ID.
t Push [
CCAALLLL
] for 1 sec. to transmit the GPS Posi-
tion Call.
• Before transmitting the GPS Position call, verify ‘SelfID’
for your own ID.
• While calling, push [CALL] to cancel the call.
• Receiving GPS Position call
When a transceiver receives a GPS Position call with
your individual ID, it automatically responds by trans-
mitting. The receiving GPS Position call is stored in
the selcall memory.
After receiving a GPS Position call and push [
ΩΩ
CLR]
or [OK
≈≈
] to select the call, the following indication is
displayed.
To Next Page
Loading...
Need help?
General
