35
5
CHANNEL/ID PROGRAMMING
DD
ALE ID
The IC-F7000 can be stored up to 20 your own IDs
(S1–S20) and 100 calling (address) IDs (1–100) for
ALE operation.
q Push [
∫∫
]/[
√√
] to select the desired ID channel, then
push [OK
≈≈
].
• Push [
ΩΩ
CLR] to return the call selection menu
.
• No ID displayed channel is a blank channel
.
• ID programming screen appears.
w Push [
√√
] to select ‘ID’ for ALE ID programming,
then push [OK
≈≈
] to edit the ID.
• ID is available up to 15 characters
.
• Push [
ΩΩ
CLR] to delete a character.
• Push [OK
≈≈
] twice to set the ID.
e Push [
√√
] to select ‘NET’ for NET ID programming,
then push [OK
≈≈
] to edit the ID.
• ID is available up to 15 characters
.
• Push [
ΩΩ
CLR] to delete a character.
• Push [OK
≈≈
] twice to set the ID.
r Push [
√√
] to select ‘CH‘ for channel range setting,
then push [OK
≈≈
].
• Edit 4-digits channel number twice.
<Input example>
• Channel range from Ch 6000 to Ch 6999
Push n, /, /, /, then n, ., ., .
.
- Small number must be input first.
• Discontinuous channels Ch 6000 and Ch 6999
Push n, /, /, / and n, /, /, /, then push n, .,
., . and n, ., ., .
.
- When input the discontinuous channels,enter the same
channel number twice.
t Push [
√√
] to select ‘SLOT,’ then push [OK
≈≈
].
• When receiving a net (group) call, the transceivers will
answer orderly following this number. Thus this number
must be assigned different number for each transceiver
in the same group.
• Deleting an ID number
q Select an ID number for deleting, push [OK
≈≈
].
w Push [
√√
] several times to select ‘DELETE ID,‘ then
push and hold [OK
≈≈
].
To Next Page
Loading...
Need help?
General
