FCC Compliance Statements
FCC PART 15, WARNINGS: INFORMATION TO USER
This equipment complies with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
⦁ Re-orient the receiving antenna.
⦁ Increase the separation between the equipment and receiver.
⦁ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
⦁ Changes or modifications not authorized by the party responsible for compliance could void the user's
authority to operate this product.
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
⦁ This device may not cause harmful interference.
⦁ This device must accept any interference received, including interference that may cause undesired operation.
NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY
APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
IMPORTANT INFORMATION
Modem model only.
This equipment complies with Part 68 of the FCC Rules and the requirements adopted by the ACTA. Inside the
cover of this equipment is a label that contains, among other information, a product identifier in the format US:
AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.
FCC REGISTRATION NUMBER: US: 48DMM00BPRTCTRLDI
RINGER EQUIVALENCE NUMBER: 0.0
USOC Jack: RJ-31X
Telephone Connection Requirements
Modem model only.
A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with
the applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant telephone cord modular
plug is provided with this product. It is designed to be connected to a compatible modular jack that is also
compliant. See this document for details.
Ringer Equivalence Number (REN)
Modem model only.
PRT-CTRL-DIN | Protege GX DIN Rail Integrated System Controller | Installation Manual 65
To Next Page
Loading...
