IFM Electronic CR0451 - Basicdisplay; Default Chapter; Table of Contents

2
ifm System Manual ecomatmobile BasicDisplay (CR0451) V01
Contents
Contents
1 About this manual 5
1.1 What do the symbols and formats mean? ...........................................................................5
1.2 How is this manual structured?............................................................................................6
2 Safety instructions 7
2.1 Important! .............................................................................................................................7
2.2 What previous knowledge is required?................................................................................8
3 System description 9
3.1 Information about the device................................................................................................9
3.1.1 Accessories ..........................................................................................................9
3.1.2 Colour display.....................................................................................................10
3.1.3 Operating elements ............................................................................................10
3.1.4 Connection on the rear panel of the housing .....................................................11
3.2 Information concerning the software..................................................................................11
3.3 PLC configuration ..............................................................................................................12
4 Operating states and operating system 13
4.1 Operating states.................................................................................................................13
4.1.1 INIT state (Reset) ...............................................................................................13
4.1.2 RUN state ...........................................................................................................13
4.1.3 STOP state .........................................................................................................14
4.1.4 ERROR state......................................................................................................14
4.1.5 FATAL ERROR state..........................................................................................15
4.2 Status LED .........................................................................................................................15
4.3 Operating system...............................................................................................................16
4.3.1 Load the operating system .................................................................................16
5 Configurations 17
5.1 Set device parameters (setup)...........................................................................................17
5.1.1 Display CAN parameters ....................................................................................17
5.2 Set up programming system ..............................................................................................17
5.2.1 Set up programming system manually ...............................................................17
5.2.2 Set up programming system via templates ........................................................21
5.2.3 ifm demo programs.............................................................................................30
5.3 First steps...........................................................................................................................34
5.3.1 Create visualisation ............................................................................................34
5.3.2 Create PLC program ..........................................................................................36
6 Limitations and programming notes 37
6.1 Limits of the device ............................................................................................................37
6.1.1 CPU frequency ...................................................................................................37
6.1.2 Watchdog behaviour...........................................................................................38
6.1.3 Available memory (CR0451) ..............................................................................38
6.1.4 Limitations for visualisations (CR0451) ..............................................................39