IFM O1D300 - 10.2.2 Carry out the basic teach empty state

23
UK
2
► Press [MODE/ENTER] until [EMP] is
displayed�
3
► Press [SET] and keep it pressed until
the preset value is flashing�
► After 5 s the setting value can be set
incrementally be pressing the button
once or continuously by keeping the
button pressed�
The value is incremented continuously� For reducing the value: let the display move to
the maximum setting value� Then the cycle starts again at the minimum setting value�
4
► Confirm with [MODE/ENTER]�
10.2.2 Carry out the basic teach empty state
The bottom of an empty tank can be set as reference level�
1
► Apply operating voltage�
> Initial display is shown�
2
► Press [MODE/ENTER] until [cEMP]
is displayed�
3
► Press [SET] and keep it pressed until
[cEMP] is flashing�