IFM O1D300 - Operation; 11.1 Operating modes; 11.1.1 Run mode; 11.1.4 Programming mode

31
UK
11 Operation
11.1 Operating modes
11.1.1 Run mode
The run mode is the normal operating mode�
After power on the unit is in the Run mode� It carries out its monitoring function
and generates output signals according to the set parameters�
The display indicates the current level (relative to the reference level), the yellow
LEDs signal the switching status of the outputs�
11.1.2 Display mode
Indication of the parameters and the set parameter values
► Press [MODE/ENTER] briefly�
> Unit goes to the Display mode� Internally it remains in the operating mode�
The set parameter values can be read:
► To scroll through the parameters, press [MODE/ENTER] briefly�
► To display the respective parameter value, press [SET] briefly�
> After another 15 s the unit returns to the Run mode�
11.1.3 Object reflectivity
Indication of object reflectivity:
► Press [SET] in the Run mode�
> The unit displays an orientation value for the object reflectivity (for instance
+100 corresponds to a white object, +020 corresponds to a grey object)�
11.1.4 Programming mode
Setting the parameter values → 10.1 General parameter setting�