Aim at the ground. The on screen indicators will guide you to
the spot directly below the Point of Interest on the wire.
Follow the arrows until your ike is aimed at the point on the
ground directly below the wire and the arrows disappear.
Once you are satisfied, Tap the Next button to continue.
Tip: If you are in a situation where you cannot see the point
on the ground directly below the wire, you can aim at a point
on the ground at the same height instead (only the vertical
height will be used at this stage).
Recompose your scene with the measurement
superimposed, and tap the Next button to finalize the
measurement.
To Next Page
Loading...