Page 29 of 50
A pipe oscillation filter has been added to the software. The filter can be activated or disabled for every load
level in the Engine Data window. The software remembers the filter state (on or off) at the next start.
6.5 IMEP- and IPOWER calculation
On two stroke application the software calculates based on mathematic algorithm automatic IPOWER and IMEP
value of each cylinder.
6.5.1 Application on two-stroke engines
6.5.1.1 Load measured data from hard disc to PC
At first the visualization software must be started.
Press “Open” to load measurement data from EPM-XP to PC.
The software opened a window for to open a stored file on PC.
After this procedure the selected data file will be monitored at visualisation software
To Next Page
Loading...