Page 45 of 50
9 Cleaning
9.1 Periodically cleaning
Clean gas channel of thompson adaptor by compressed air periodically (see fig. 22)
Fig. 22: Periodically cleaning of gas channel
9.2 Cleaning in case of hard deposit
For elimination hard deposit please disconnect sensor from adaptor by using tools with wrench size 19mm and
22 mm (fig.23). Before disconnection of sensor from adaptor spring must be disconnected from adaptor (fig.24).
This procedure should only be done if accuracy of measured values is incorrect!
Fig. 23: Disconnection of spring Fig.24: Disconnection of HTT cylinder pressure sensor
from adaptor
To Next Page
Loading...