Immergas MAGIS COMBO PLUS V2 Series - Parameters for Filling in the Package Fiche

98
INSTALLER
USERMAINTENANCE TECHNICIAN
TECHNICAL DATA
4.5 PARAMETERS FOR FILLING IN THE
PACK AGE FIC HE
Should you wish to install an assembly starting from the Magis
Combo Plus V2 package, use the package che shown in (Fig. 78).
For correctly lling in, enter the gures into the specic spaces (as
shown in the facsimile package che Fig. 77) found on the tables of
paragraphs "Parameters to ll in the low temperature package
che (30/35)", "Parameters to ll in the average temperature pack-
age che (47/55)".
e remaining values must be obtained from the technical data
sheets of the products used to make up the assembly (e.g. solar de-
vices, integration indoor unit, temperature controllers).
Use sheet (Fig. 78) “assemblies” related to the central heating
function (e.g.: heat pump + temperature controller).
Since the product is standard supplied with a tempera-
ture controller, the package che must always be com-
pleted.
Facsimile for lling in the package che for room central heating systems.
%
Temperature control
From temperature
control board
Supplementary boiler
From boiler board
ter climate conditions
the heat loss in the distribution system and the size of the products compared to the size and
features of the building.
climate conditions
climate conditions
Solar contribution
From the board of the solar device
Class I = 1 %, Class II = 2 %,
Class III = 1.5 %, Class IV = 2 %,
Class V = 3 %, Class VI = 4 %,
Class VII = 3.5 %, Class VIII = 5 %
%
+
%
-
(%)
( - ‘I’ ) x “II” =
%
%
+
Dimensions of the
manifold (in m
2
)
Volume of the
tank (in m
3
)
manifold (in %)
tank
A* = 0.95, A = 0.91,
B = 0.86, C = 0.83,
D-G = 0.81
( ‘III’ x + ‘IV’ x ) x 0.45 x ( / 100) x =
% %
‘I’
Colder: - ‘V’ = Hotter: + ‘VI’ =
G F E D C B A A
+++
A
++
A
+
< 30 % 30 % 34 % 36 % 75 % 82 % 90 % 98 % 125 %150 %
77