IMT 5525

105
In This Chapter
Inspection Checklist .................................................................. 105
Deficiency / Recommendation / Corrective Action Report ......... 110
Wire Rope Inspection & Replacement ...................................... 112
Hook Inspection ........................................................................ 113
Holding Valve Inspection .......................................................... 114
Anti-Two-Block Device Inspection ............................................ 114
Thread Torques ........................................................................ 115
Turntable Bearing Thread Tightening Sequence ...................... 118
Turntable Bearing Inspection .................................................... 119
Turntable Bearing Tilt Test ....................................................... 119
Inspection Checklist
NOTICE:
The user of this form is responsible for determining that these inspections satisfy all applicable
regulatory requirements.
OWNER/COMPANY:
TYPE OF INSPECTION (circle one):
CONTACT PERSON:
DAILY
MONTHLY
QUARTERLY
ANNUAL
CRANE MAKE & MODEL:
DATE INSPECTED:
CRANE SERIAL NUMBER:
HOURMETER READING (if applicable):
UNIT I.D. NUMBER:
INSPECTED BY (print):
LOCATION OF UNIT:
SIGNATURE OF INSPECTOR:
C HAPTER 5
General Reference