iNetVu
®
Mobile Installation Manual Page 14 of 93
Chapter 3: iNetVu
®
Mobile System Installation
THE iNetVu
®
MOBILE PLATFORM SHOULD NEVER BE
OPERATED WITHOUT ITS CONTROLLER AND SHOULD
NEVER BE CONNECTED DIRECTLY TO A BATTERY.
DOING SO WILL VOID THE WARRANTY ON BOTH THE CONTROLLER AND THE
PLATFORM AND THE CUSTOMER WILL BE CHARGED FOR REPAIR AND
REPLACEMENT COSTS RELATING TO THE DAMAGE.
THE POWER TO OPERATE THE MOBILE PLATFORM SHOULD ALWAYS BE
CONNECTED TO THE CONTROLLER VIA ITS APPROPRIATE POWER CABLE, WHICH IS
FUSED. POWER SHOULD NEVER BE APPLIED DIRECTLY TO THE PLATFORM TO
RAISE OR LOWER IT WITHOUT THE USE OF THE CONTROLLER.
NOT FOLLOWING THESE INSTRUCTIONS WILL SEVERELY DAMAGE THE PLATFORM
AND WILL ALSO DAMAGE THE CONTROLLER ONCE IT IS ATTACHED TO THE
PLATFORM THAT HAS BEEN SUBJECTED TO DIRECT BATTERY OPERATION WITHOUT
THE USE OF THE CONTROLLER.
3.1 General
All iNetVu
®
Mobile Systems have been fully tested with the iNetVu ® Controller prior to
shipment. All position feedback; limit sensing, limit switches and motor speeds have been
calibrated and preset prior to shipping. The wave-guide, the boom mounted Radio Transmitter
cables and the Transmission/Receive coaxial cables have all pre-wired. There is no need to
re-calibrate the Mobile Platform unless directed by a C-Com Support Technician.
It is critical that the iNetVu
®
Controller stay together with the Mobile Platform it shipped with.
You may refer to the iNetVu
®
Shipping Checklist to confirm this.
The iNetVu® Mobile System has been designed for either roof rack mounting or mounting
directly to a vehicle. The iNetVu
®
Mobile Platform should always be secured to the vehicle.
To Next Page
Loading...