iNetVu
®
Mobile Installation Manual Page 62 of 93
4.6 Installing BUC to iNetVu
®
1200/1500/1800 Mobile Platform using
Universal Bracket Kit
This procedure describes the steps involved for installing a Block Up Converter (BUC) to the
iNetVu
®
1200/1500/1800 Mobile Platform. The installation procedure described below shows
images for a 4W BUC, but may be utilized for any sized BUC installation.
Required Materials:
• iNetVu
®
1200/1500/1800 Mobile Platform
• Universal Transmitter Mounting Bracket Kit
• BUC (Block Up Converter)
• Phillips Screwdriver
• Allen Key Set
Procedure:
1. Ensure Block Up Converter (BUC) includes an o-ring.
2. Remove Universal Transmitter Mounting Brackets from the underside of the feed arm,
if attached.
3. Place and secure the BUC on the underside of the Feed Arm as depicted in the figure
below.
When securing the BUC, adjust the placement of the screws and brackets to ensure the
following:
a. The BUC is placed at the far right side of the Feed Arm (if facing the Reflector),
using the holes on the far right side of the Feed Arm. This will ensure that the
Flexible Waveguide does not bind or twist during Polarization Adjustments.
b. Ensure enough space is left between the BUC and the Feed Arm Bar where the
springs are attached (if applicable) to ensure you have enough space to attach
the Flexible Waveguide to the BUC.
c. The RG6 Coaxial Connector end of the BUC is facing the Reflector.
d. The long screws of the Universal Transmitter Mounting Bracket Kit are fed
through the grooves on each side of the BUC, if applicable.
To Next Page
Loading...