iNetVu
®
Mobile Installation Manual Page 80 of 93
4.13 A1200 B/C Co-Pol Installation Assembly
Description:
This procedure describes the steps involved in changing the polarization cage on the 1.2
Mobile systems.
Required Materials:
Allen Key Set
Philips Screw Driver
Replacement Feed Assembly
Solution(s):
1) Disconnect the RX Cable from the LNB.
2) Disconnect the polarization pot, and the polarization motor cables from the internal wiring
harness. You may have to cut through some of the tie wraps to loosen up the cables.
To Next Page
Loading...