20 5Installation
Translation of the original operating instructions Ecotec E3000, kina22en1-19, 1507
7 Screw the plastic capillary filter on the sniffer probe.
8 Calibrate the Ecotec E3000, see “6.4.2 Calibration”, page 37.
5.2.1.3 Water conservation sniffer probe mounting and remove
With the help of the water conservation sniffer probe, you can check test objects with low
surface moisture, e.g. condensation moisture, for tightness.
The water conservation sniffer probe is screwed onto the sniffer probe end like the metal
capillary filter. The small plugwasher must also be placed below the end, see
“5.2.1.2 Replacing the metal capillary filter with the plastic capillary filter”, page 19.
Fig. 8: Tightening the water conservation sniffer probe
For renewed mounting of the plastic capillary filter, see “5.2.1.1 Replacing the plastic
capillary filter with the metal capillary filter”, page 19.
Short circuit hazard
Sucked in liquid can destroy the device.
► Do not suction in liquids with the device.
To Next Page
Loading...
