To Next Page

To Previous Page

28 6 Operation

Translation of the original operating instructions Ecotec E3000, kina22en1-19, 1507

6.3 Settings before measurements

Before the first measurements, you should make different device settings in the following

menus:

 Miscellaneous

 Display

 Audio

 Vacuum & access control

 Interfaces (for control via interfaces and if you use an ECO-Check)

You can access the menus via the main menu

6.3.1 Miscellaneous

Language You can select one of the following languages:

 English (factory setting)

 German

 French

 Italian

 Portuguese

 Spanish

 Japanese (Katakana)

 Chinese (Mandarin, simplified Chinese)

To set the language to English temporarily, press keys two and six during the run-up of the

Ecotec. Call up the language setting after the run-up and set the required language.

Time & Date  First page: internal date with the format DD.MM.YYYY

 Second page (press key on the bottom right ) time with the format SS:MM.

Sniffer light  Activate/deactivate light

 Adjust brightness from 1 (min) to 6 (max)

Pressure unit  atm

 Torr

 Pa

 mbar

Leak rate filter  Auto

 Fixed

 I•Filter

The I•Filter is an intelligent filter algorithm that delivers the best results regarding

interference suppression and stability of the leak rate signal. It was especially developed

for the use in the Ecotec E3000.

Only in cases in which the older Ecotec II model was replaced with an Ecotec E3000 and

the Ecotec E3000 is used in a fixed test device can it be necessary to select the older filter

settings “Auto” or “Fixed”.

Inficon Ecotec E3000 Original Operating Instructions

Other manuals for Inficon Ecotec E3000