Inficon Ecotec E3000 Original Operating Instructions

6Operation 49
Translation of the original operating instructions Ecotec E3000, kina22en1-19, 1507
Fig. 37: Search for gas R134a with I•Guide program 1: The trigger value and the overall leak rate were
exceeded at measuring points 1 and 3
The next measurement cycle starts if you confirm with “OK” or press the right key on the
sniffer handle.
Changing the I•Guide
program
The new I•Guide program must be set and activated in the I•Guide settings, see above.
► Open the list of I•Guide programs in the main menu with and select one.
Measurement will start immediately.
Resetting the I•Guide
cycle counter
In the window “Setup I•Guide”, you can reset the I•Guide cycle counter manually with the
key “Reset counter”.
The cycle counter is always set to zero when the device is switched off.
Fig. 38: Cycle counter reset

Inficon Ecotec E3000 Specifications

General

Brand	Inficon
Model	Ecotec E3000
Category	Security Sensors
Language	English