6Operation 51
Translation of the original operating instructions Ecotec E3000, kina22en1-19, 1507
Table 7: Device information
Menu item Format Description
Page 1: General data
Backing pressure mbar Pressure on the mass spectrometer inlet
Flow sccm Flow through the sniffer line
Total pressure mbar Pressure in the mass spectrometer
Time since power on min
Operating hours h
Serial number 9000 XXX XXXX
Software version x.xx.xx
Electronic system temp. °C / °F Temperature of CPU board
TSP temperature °C / °F Temperature of mass spectrometer
Calibrated leak temperature °C / °F Temperature of ECO-Check
Page 2: Turbo molecular pump data
State On / Off / Run-up
Curr. error code
Speed Hz
Current A
Voltage V
Driving power W
Operating hours of the TMP h Operating hours of the turbo molecular pump
Operating Hours TC h Operating hours of the frequency converter for TMP
Run-up time s
Software version XXXXXX
Page 3: Transpector data
Configuration
Box version x.xx
Control SW version x.xx
Measure SW version x.xx
Filament A or B/A or B Set cathode / active cathode
Power on time h
Emission on time A h
Emission on time B h
TSP temperature °C / °F Temperature of mass spectrometer
Argon position + / - x.xx
Page 4: ECO-Check Data
Gas Rxxx Gas of internal leak
Leak rate nom. / at T x.x g/a / x.x g/a Nominal leak rate / leak rate at current temperature
Version / Checks. x.x / hexadecimal code Software version with checksum
Serial no. 9000 XXX XXXX
Serial no. reservoir 9000 XXX XXXX
Filling date DD.MM.YYYY
Expiration date DD.MM.YYYY
Gain / Offset Parameters for the temperature measurement in the ECO-Check