InkJet DuraCode Series - 2.6.4 INK SYSTEM

Page 9
2.6.4 INK SYSTEM
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
1. Flushing the nozzle blockage automatically.
2. After performing , open the printhead cover and use cleaning agent to clean the nozzle
manually.
3. It is used to control the pump, valve and other parts separately.
4. Used for cleaning umbilical , only for commissioning engineers to use when debugging.
5. It is used to quickly start the jet, without auto cleaning.
6. For quick stop inkjet without auto cleaning.
7. For setting the ink type, built-in B600, 601, A630, 680, 619, 669, 2630, 2631, 263, 273
and 630.
8. Used to set the ink viscosity, manual / auto optional;
9. Used to calibrate the standard reference pressure;
10. For the entire ink system cleaning, follow the on-screen instructions
11. Used to exhaust the air, usually for commissioning.
12. Open/Close the positive air to the printhead after positive air pump installed.
13. Used for the first time cleaning after the printer is assembled
14. Used to select the printhead type, according to the mark on the print module base.
15. For setting the time for automatic printer shutdown (1 to 99 hours)
16. It is used to fill the mixer tank with ink to the OK level. It is used when the machine is
first time use.