3.7.5 Repeat Printing Mode
In this mode you can set the specific numbers of printing per trigger.
1. Press PRINT SET button to enter the following setting interface:
* The GRAY options indicate that the setting is invalid for the Repeat Mode.
2. Switch the "Print Mode" to “Repeat" then the printer is in the repeat printing mode.
a
b
c
d
e
f
Setting analysis:
a. The option sets the internal interval between each messages.
Options b. c. d. e. take effect after "Shaft Encoder" is set as “external”.
f. The option sets the printing times.
3. Other valid settings please refer to "2.6.3 PRINT SET Menu Analysis".
4. if you are not using the "Repeat" mode, please leave the "Print Times" as 1.
To Next Page
Loading...