Innovative Technology BV50 - Pulse; General Description; Pin Assignments; Inhibit Control

<< Back to Contents
Copyright © Innovative Technology Ltd 2020 Doc: BV50 User Manual
Version: 1.0
Page 36 of 63
6.8 Pulse
6.8.1 General Description
Pulse can be used for the acceptance of up to 16 channels. When a note is
recognised vend 1 (pin 1) will pulse a pre-set number of times. The amount of
pulses as well as the high/low pulse ratio is configurable. For programming and
configuration please refer to Section 5 of this User Manual.
Caution!
Pulse is an unsecure interface and
should not be used for new
developments!
6.8.2 Pin Assignments
Pin
Name
Type
Description
1
Vend 1
Output
Credit Output Pulse Stream
5
Inhibit 1
Input
Inhibit Input Channel 1
6
Inhibit 2
Input
Inhibit Input Channel 2
7
Inhibit 3
Input
Inhibit Input Channel 3
8
Inhibit 4
Input
Inhibit Input Channel 4
9
Busy
Output
Output Busy Signal
10
Escrow
Input
Input Escrow Control
15
+ Vin
Power
+12VDC Supply
16
0V
Power
0V Supply (GND)
6.8.3 Inhibit Control
The Inhibits can be used to either enable or disable the acceptance of those
banknotes programmed on channels 1, 2, 3 and 4. The Inhibits are internally held