Innovative Technology NV11 - Page 103

NV11 Manual Set – Section 4 12
Copyright © Innovative Technology Ltd 2012 GA963-2
Information
Power always required
regardless of connection
type.
Power is always required on pins 15 and 16 of the
16 way connector.
The connector is a 16 pin socket used to interface the NV11 to the host machine. The
pin numbering of the socket is shown below, as well as an overview of the socket
connections:
To use a USB connection with the NV11, a USB cable fitted with a 16 way connector
on one end (ITL Part Number CN392) should be used. The CN392 cable fits into the
16 way connector and allows high speed programming and serial communications
when used in SSP and ccTalk modes.
When using the USB connection, power must be supplied to the NV11 using the
CN392 cable. The socket connections for the natively supported protocols are shown
in the tables below:
WARNING!
Risk of unit damage
Do not make any connections to the interface socket
pins marked ‘Do not connect’ – making connections
to these pins could cause severe damage to the unit.
Pin
Description
1
Serial Data Out (Tx)
5
Serial Data In (Rx)
11
USB Data +
12
USB Data -
13
USB Power (+5V)
15
+ V
16
0V / Ground Connection