NV11 Manual Set – Section 4 27
Copyright © Innovative Technology Ltd 2012 GA963-2
4.11 Guidance Notes
Cleaning
The NV11 validator has been designed in a way to prevent damage and airborne
contamination reaching the optical sensors; however, depending upon the
environment the NV11 may require occasional cleaning or belt changing.
Do not use solvent based
cleaners on any part of the
NV11 unit.
Do not use solvent based cleaners such as
alcohol, petrol, methylated spirits, white spirit or
PCB cleaner. Using these solvents can cause
permanent damage to the unit; only use a mild
detergent solution as directed below.
To clean the NV11, open the note
path by sliding the red release catch
on the front of the validator to the
left (as indicated in the picture) - this
will allow access to the lozenge and
note path
To Next Page
Loading...
