NV9 Spectral Range Manual
<< Back to Contents
Copyright © Innovative Technology Ltd 2019 Doc: GA02156 NV9S Range User Manual
Version: 1.1
Page 47 of 54
Frequently Asked Questions
Q1. Why are there no DIP switches on the unit?
A: The NV9 Spectral has no dipswitches. Configuring the unit is carried out using a
configuration button mounted on top of the unit – see subsection 2.4.4 of this
manual for more information.
Q2. In what orientation can I use the NV9 Spectral validator?
A: The NV9 Spectral can be mounted horizontally or vertically, depending on the
type of bezel and cashbox selected. check the ITL website to see the currently
available range of cashboxes and bezels.
Q3. How do I check which interface has been set?
A: You can check which interface has been selected by using the configuration
button mounted on top of the unit – see subsection 2.4.4 of this manual for more
information.
Q4. How do I change the interface type?
A: You can change the interface type by using the configuration button mounted on
top of the unit – see section 2.4.4 of this manual for more information.
Q5. Some or all notes are not accepted
A: Check that no inhibits are set in the Validator Manager software (see section 5 of
this manual set). If the problem persists, contact ITL Support for further assistance.
To Next Page
Loading...
