Commissioning Tools
‑16‑
Key Name
Description
Navigation key In the secondary display area, press the right or left
navigation key to switch the display status.
Primary display area:
● Basic menu, user menu, and calibration menu: On
the monitoring interface, the down key is used as
the potentiometer and the left and right keys are
used to switch between monitored variables. On
the parameter interface, the up and down keys are
used to adjust the setpoint, the left and right keys
are used to select the bit to set, and the OK key is
used to confirm the setpoint.
● Fault list: Press the left or right key to switch the
fault history records.
Multi‑function
key
You can allocate different functions, such as
command source switch, forward run and reverse
run switch, or jog to this key.
RUN key Press the key to start the drive in the operating panel
control mode.
Stop/Fault reset
key
When the drive is running, press this key to stop the
drive.
When the drive is in the faulty state, press this key to
perform a reset operation.
To Next Page
Loading...
